Roach 192CDLR Medium-Duty Roll-to-Roll Chain Driven Live Roller Conveyor

Chain Driven Conveyor Transports Totes, Drums & Pallet Loads

The Roach 192CDLR medium-duty chain driven live roller conveyor is designed to transport loads such as tote pans, castings, drums or pallet loads.

Specifications

Tread Rollers: 2-1/2" dia. to 1-11/16" dia. x 14 ga. steel tapered rollers, model 254T; 1.9" dia. x 16 ga. steel straight tangent rollers, model 196S.

Roller Centers: 1-9/16" measured at inside radius of unit.

Pressure Sheaves: Provides drive belt pressure to upper tread rollers.

Belt: B section V-belt.

Take-Up: Screw type adjustable sheave with flat idler sheaves to maintain belt tension.

Tangents: 1'-0" both ends on 90 ; 1'-6" both ends on 45 ; 1'-0" both ends on 180 degrees. Tangent roller centers provided on 3" RC.

Bed: 7" x 1-1/2" x 12 ga. formed steel channel frame.

Speed: 60 FPM, constant.

Bearings: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.

Roller Chain: Drive shaft is driven by No. 50 chain.

Motor Drive: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located at infeed end of curve below bed on 45 degree and 90 degree curves; 3/4 HP supplied on all 180 degree curves.

Drive Location: Drive located on outside of curve. Specify left hand tangent length, right hand tangent length and drive location (left hand drive or right hand drive). Note: Drive hand determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.

Capacity: 500 lb. total distributed live load.

Options

Speed: Constant speed 1.5-100 FPM; DC variable speed; AC inverter variable speed. Other constant or variable speeds available. Note: Capacity changes with speed. 100 FPM Max with roll-to-roll chain drive.

Motors: Available through 3 HP in TEFC, explosion proof, dirty duty, brake motor, 115/230/1, 575/3, etc.

Floor Supports: Supports, knee braces, casters and polytier supports available.

Undertrussed Bed: Available to provide clearance underneath unit at bed joint locations. Specify location for undertrussing and desired clearance underneath unit.

Guard Rails: 1-3/4" x 1" formed channel (model GC), adjusts horizontally to 8" wider than roller and vertically to 6" above roller; formed steel fixed (model FSG) in 2", 4" and 6" heights; fixed channel (model FC); 1-1/2" angle (model GA1-1/2).

Ceiling Hangers: 5/8" dia. threaded rod with hardware to attach rods to conveyor. Provides 6' clearance between ceiling and TOR (furnished in place of floor supports).

Electrical Controls: Magnetic starter; one direction manual starter; momentary start/stop push button station; limit switch, photo relay; others available.

Please contact Pro Pac or call 888-318-0083 for your conveyors.

Please contact Pro Pac or call 888-318-0083 for your conveyors.